Reverse Band Deadlift

Also called reverse band deadlift and band assisted deadlift.

Works

Lower back, plus side glutes, adductors, calves, glutes, hamstrings and quads

Equipment

Barbell

Level

Advanced

Type

Compound

How to do it

Setup. Set the bar up in a power rack. Attach bands to the top of the rack, using either bands pegs or the frame itself. Attach the other end of the bands to the bar.

1. Approach the bar so that it is centered over your feet. You feet should be about hip width apart. Bend at the hip to grip the bar at shoulder width, allowing your shoulder blades to protract. Typically, you would use an overhand grip or an over/under grip on heavier sets.
2. With your feet, and your grip set, take a big breath and then lower your hips and bend the knees until your shins contact the bar. Look forward with your head, keep your chest up and your back arched, and begin driving through the heels to move the weight upward.
3. After the bar passes the knees, aggressively pull the bar back, pulling your shoulder blades together as you drive your hips forward into the bar.
4. Lower the bar by bending at the hips and guiding it to the floor.

Cues

• Bar over mid-foot.
• Grip and pull the slack out.
• Push the floor away.
• Lock out with the glutes.

Common mistakes

• Back rounding off the floor.
• Hips shooting up first.

Where to start

A starting point, not a law. Pick a weight you could lift two or three more times than the top of the range. Tempo is seconds down, pause, up. When every set hits the top of the range, add a little weight.

Go easy, or pick an alternative, if you have a cranky lower back. Pain that's sharp or gets worse set to set means stop.

Swap for