Axle Deadlift
- Works
- Lower back, plus forearms, glutes, hamstrings, upper back, quads and traps
- Equipment
- Other kit
- Level
- Intermediate
- Type
- Compound
How to do it
Setup. Approach the bar so that it is centered over your feet. You feet should be about hip width apart. Bend at the hip to grip the bar at shoulder width, allowing your shoulder blades to protract. Typically, you would use an over/under grip.
- With your feet and your grip set, take a big breath and then lower your hips and flex the knees until your shins contact the bar. Look forward with your head, keep your chest up and your back arched, and begin driving through the heels to move the weight upward.
- After the bar passes the knees, aggressively pull the bar back, pulling your shoulder blades together as you drive your hips forward into the bar.
- Lower the bar by bending at the hips and guiding it to the floor.
Cues
- Bar over mid-foot, double overhand.
- Crush the bar hard.
- Push the floor, bar on the legs.
- Lock out with the glutes.
Common mistakes
- Back rounding off the floor.
- Grip slipping and jerking.
Where to start
Sets3
Reps3-5
Rest3 min
Tempo1-0-1
A starting point, not a law. Pick a weight you could lift two or three more times than the top of the range. Tempo is seconds down, pause, up. When every set hits the top of the range, add a little weight.
Go easy, or pick an alternative, if you have a cranky lower back. Pain that's sharp or gets worse set to set means stop.